Description
Finally we have a good quality rebuilt Metro 4:22 rear end. The 4:22's were used from serial number E-21008 & up.
You can use this on any Metropolitan but doing that will cause some fluctuation in your speedometer reading, if not using with the correct corresponding parts according to your serial number. We have a good tech sheet on this in the footer of every page that you can check out.
Our rebuilt rear ends are professionally rebuilt including the following new parts: 2 carrier bearings, 1 of each front & rear pinion bearing, a new installed seal, & the mounting gasket. Thrust washers, shims, & the pinion gear axle are replaced as needed. Gears & all other parts are thoroughly checked out and cleaned to run smoothly. Shimmed correctly and ready to install. No need to re torque the flange that connects to your drive shaft as that is already done.
Core Charge - 200.00. You have to send back a 4:22 rear end for any core refund. The ring and pinion gears will also have to be in good shape since the new ones are much more expensive then the core charge. Remember to send back the driveshaft flange also. Depending on the condition of your core it could take up to 2 weeks or so (once receiving) for the refund to have our specialist check it out.